The 50-hours inspection of the ignition and electrical system of the USAAF B-24 Liberator heavy bomber aircraft at an airfield in the United States. The electrical specialist checks the regulators in the aircraft nose compartment. The specilaist checks starters and removes window strap for proper inspection. The specialist checks brush condition and inspects the heaters. He takes out screws and pulls out back casting and inspects the back plate for deformation of metals. The electrical specialist uses air hose to clean the oven. He checks and cleans the igniter using a brush. The specialist makes a similar inspection with the side heaters and cleans solenoid belt. He runs the motor and checks its functioning. He inspects the battery plug connection on the outside of the aircraft. He checks the A/C inverter. O perational check of alarm bell is done. He opens the fuse box to repair it, and with the help of a diagram he replaces the bad fuse with the new fuse. The aircraft in flight after completion of inspection.
"Making Steel for War" shows powered shovel digging iron ore out of an open pit mine. After obtaining the Iron Ore ,it is crushed and shipped to steel mills. Countless open railroad cars filled with iron ore in a marshalling yard. Iron ore being loaded into an ore carrier ship. The ship carrying the Iron Ore reaches its destination, where huge cranes with claw buckets reach in and remove the iron ore from the ship. View of steel mill complex including rail yard, furnaces, and numerous structures. Powered shovel digging limestone out of open pit mine and loading it on to conveyer. Coal being discharged from coking ovens and bursting into flames when it contacts the open air. .
The raw materials used in manufacturing of steel are carried by ore cranes and transfer cars, into a blast furnace, to be smelted. Steel workers drill out the clay tap plug, tapping the blast furnace, and molten iron runs out into runners in floor, amidst flame, smoke and fumes. A technician reads the temperature of the pour using an optical pyrometer.The molten iron creates flames, smoke and fumes as it progresses to empty into a large specially designed rail car, pulled by a locomotive.
Adding scrap to the charge of an open hearth furnace during steel making. Steel Workers use crane to pick up scrap for adding to the charge of an open hearth furnace. Workers sort scrap by noting the kinds of sparks produced as it is touched to a grinding wheel. Scrap is charged into the furnace by means of machines on rails. Operator seen at controls of charging machine. Under control of operator seen in booth above, molten iron is poured into the furnace from a huge Ladle. . Workers manually shovel Ferro manganese into the furnace, in measured quantity, to control the oxygen content. Furnace is tapped by burning and ramming a plug and molten steel flows in ladle. Molten steel is 'teemed' into ingot molds. Technician checks temperature of the steel with an optical pyrometer.
Steel is manufactured in sufficient quantities in electric furnaces where higher temperatures are attained under close control in a manufacturing plant. Two workers inspect the furnace. Another worker manipulates electrical switches and controls on a panel. Molten iron seen splashing through open furnace door. Workers wearing protective glasses manually shovel measured quantities of alloying elements into the hot furnace at the factory.
Manufacture of Steel during World War II in United States. Bessemer converter seen in tilted position being charged with molten iron from a ladle, under control of crane operator. Bessemer converter operator manipulates lever to cause converter to tilt up and air to blast through the molten iron. This burns excess carbon, silicon and manganese and converts the iron into steel. Molten steel is poured into molds. which are removed after steel solidifies. Hot ingots are moved on rail cars to a place, where they attain a uniform temperature and are ready for rolling. Ingots stored in pit.